These following 3 steps assume you have verified your gas is turned on and you have good flow to your machine. You should watch the ignitor through the viewing glass to make sure you see spark. If all of that is good, then you can try the following additional steps.
STEP 1: Check Your Exhaust dampeners screw settings.
If you have not adjusted the screws that limit how far the exhaust doors can open then you may be exhausting air too fast and it is preventing the gas from igniting. You should consult the How-To video on tuning your dryer. Adjust both the front and rear door limit screws to be 2cm or about 1".
Step 2: Adjust your Gas Valve.
You may need to adjust your gas valve. Consult the tuning how-to video.
After removing the gold cap covering the adjustment screw for the gas flow, you should use a flat headed screwdriver and turn it all the way to the right (Clockwise) until it stops. Then turn it left (Counter clockwise) 1 full rotation.
Step 3: Adjust the gap on Ignitor.
If you continue to have ignition errors, check the gap on your ignitor and make sure it falls into the range of 2.8mm to 3.8 mm.
